Defy DDW178 - Rinse Aid Indicator ( ); End of Programme; Water Cut-Off Warning; Overfowing Warning

36
EN
Rnse Ad ndcator ( )
Please check the rnse ad ndcator
on the dsplay to see whether there
s adequate amount of rnse ad n the
dshwasher or not. You need to refll
the rnse ad reservor wth rnse ad
whenever rnse ad ndcator appears
on the dsplay of your machne.
End of programme
End of Programme ndcator wll lght
up once the washng programme s
over.
1. Press the On/Off key to turn off
your machine.
2. Close the tap.
3. Unplug the machine from the
socket.
C For energy saving, the machine is
automatically turned o following
the completion of the programme
or if the programme is not started.
C Leave your dishes in the machine
for about 15 minutes to allow
them cool down after they are
washed. Your dishes will dry in a
shorter time if you leave the door
of your machine ajar during this
period. This process will increase
the drying eectiveness of your
machine.
Water cut-o warnng
If mans water s cut or water nlet
tap s turned o the machne cannot
take water n and P2 con wll ash
on the programme ndcator. As
long as the problem contnues,
washng programme s paused and
the water nlet s checked regularly
by the machne; when the water s
restored P2 con wll dsappear after
a whle and the washng programme
resumes.
Overowng warnng
If the machne ntakes too much
water or there s leakage at any of
the components then the machne
wll detect ths and P1 con wll ash
on the Programme ndcator. As long
as the overowng contnues safety
algorthm wll be actve and try to
dscharge the water. If overowng
stops and safety s assured, P1
con wll dsappear. If P1 does not
dsappear, there s a permanent fault.
In ths case the authorsed servce
should be contacted.