Page 12
Maintenance and cleaning
Unplug the dryer from the mains
before attempting any cleaning or
maintenance work.
Cleaning the lint filter
• The lint filter collects lint and loose fibres
during drying and must be cleaned before
or after each drying cycle.
• To clean the filter, open the door and
remove the filter by pulling it up and out.
• Open the filter as shown.
• Clean the accumulated lint by hand or
using a soft cloth.
• Rinse under running water if necessary to
open the pores in the mesh.
• Dry and close the filter
• Reinsert it in it’s housing.
Cleaning the door and door gasket
Clean the entire inner surface of the door
and the door gasket with a moist cloth.
Cleaning the moisture sensors
• Humidity sensors are located on the
inside of the drum ribs. These determine
when the laundry is dry.
• The ribs should be cleaned every three
months.
• Wait till the dryer has cooled down and
wipe the ribs with a soft cloth dipped in
vinegar, then wipe dry.
Draining the water tank
• Dampness from the laundry is removed
during drying and condenses in the water
tank
• Drain the tank after each drying cycle.
• Should you forget to drain the tank, a
warning symbol in the display will display
when the tank is full.
• Open the drawer and carefully remove
the tank.
10
To Next Page
Loading...
