Getting
started
Select proper AC voltage
Place on level surface
Turn Degritter on
Put water into the tank
Insert the record into the machine
Press start
1) SELECT PROPER AC VOLTAGE
2) PLACE ON LEVEL SURFACE
GETTING STARTED
Degritter must be placed on a level surface for it to function properly.
Plug one end of the power cable into the machine and the other end
into your wall output. Turn on the machine from the AC switch at the back.
5) INSERT THE RECORD INTO THE MACHINE
Insert the 12” record into the machine as shown.
6) PRESS START
Start the quick washing program by pressing the button on the right.
Washing progress is tracked by the countdown timers on the screen.
You will be alerted with three beeps when the program finishes.
4) PUT WATER INTO THE TANK
Fill the water tank with distilled water to a level exceeding the “Min”
marking. It is recommended to fill it past the "Max" marking.
Make sure that the slide switch is in the position indicating your wall
output voltage, either 230 V or 115 V. Use the tip of a pen to slide the switch.
10 Getting started
An incorrect AC setting will damage the product and is not covered
by the product warranty.
To Next Page
Loading...