Degritter Automatic Record CleaningMachine - Solving error codes; No Tank error; Run Drain error; No Water error

Solving
error
codes
ERR Sens1 - ERR Sens6
ERR Temp
No Tank
Run Drain
No Water
Fill Fail
Drain Fail
Temp High
ERR P1srt - ERR P2srt
ERR P1opn - ERR P2opn
ERR V1srt - ERR V2srt
ERR V1opn - ERR V2opn
1) ERR SENS1 - ERR SENS6
2) ERR TEMP
3) NO TANK
ERROR CODES
Explanation: the machine is unable to get
a temperature reading.
Solution: turn the machine off from the
back panel AC switch and on again.
5) NO WATER
Explanation: no water is detected in the
machine.
Solution: pour water into the tank.
If this does not help, contact customer support.
6) ADD WATER
Explanation: the machine has failed to fill
the ultrasonic tank.
Solution 1: check if the water tank is
properly docked into the machine.
Solution 2: make sure that there is
enough water in the water tank.
If this does not help, contact customer support.
4) RUN DRAIN
Explanation: there is water in the
ultrasonic tank.
Solution: run the Drain function by
pressing both buttons while Info menu is
selected.
If this does not help, contact customer support.
26 Solving error
codes
27 Solving error
codes
ERR Sens1
ERR Temp
Run Drain
No Water
Add Water
No Tank
Explanation: there is no water tank in
the machine or it is not sensed.
Solution 1: insert the water tank into
the machine.
Solution 2: if the water tank already is in
the machine, remove it from the
machine and put it back again.
If this does not help, contact customer support.
Explanation: trouble with measuring the
water level.
Solution 1: turn the machine off from the
back panel AC switch, wait 10 s, and then
turn the machine on again.
Solution 2: refer to sensor cleaning guide
in Support Center.
If this does not help, contact customer support.
If this does not help, contact customer support.