9
©
1999 Directed Electronics, Inc.
Pressing for one second disarms the system and unlocks the
doors (if connected). The horn will honk twice (if connected) and
the parking lights will flash twice to confirm disarming of the sys-
tem. The optional Failsafe
®
Starter Kill will be deactivated. The sta-
tus LED will turn off, unless the system is programmed for Passive
Mode. In Passive Mode, the status LED will flash rapidly when the
system is disarmed. This indicates that the system will re-engage
the starter kill and re-lock the doors (if Passive Locking has been
programmed) in 30 seconds unless the ignition is turned on.
NOTE: This feature is only available when the optional Failsafe
®
Starter
Kill has been installed.
If your remote transmitter is lost or damaged, you can manually
override the starter kill. To do this, you must have the vehicle's
ignition key and know where the Valet
®
switch is located. Be sure
to check with the installer for the location of the Valet
®
switch.
To override the starter kill, turn
the ignition on and press the
Valet
®
switch within 10 seconds.
The status LED will stop flashing
and the vehicle should start. If it
does not start, you may have
waited too long; turn the igni-
tion off and repeat the process.
LOCATION OF VALET
®
SWITCH______________________________
To Next Page
Loading...