Dektak XT - Unloading and Powering Down; Sample Unloading Procedure; System Power Down

abletorightclickonyourdatatosetyourreferencecursortozeroandlevelyourdata.
Analysis:
1.Selectthe“DataAnalysis”Screen(ifyou’renotalreadythere).Youshouldseeatraceof
yourdatainthe“DataAnalysis”box.
2.Rightclickinsidethe“AnalyticalResults”boxandselect“Append”.
Youcanthenselectwhateveritisthatyouwanttomeasure,andselectalocationforR
andMcursors.Whenyouhit“Calculate”youwillseeallofthosevalueslistedinthe
AnalyticalResultsbox.
UnloadingSample:
1.Hit“TowerUp”.
2.Hit“Unloadsample”.
3.Eitherloadanewsampleorpowerthesystemdown.
TopowerdowntheDektakXTsystem:
1.ClosetheVison64software.
2.PresstheblackOFFbuttonontheEMOBox.
3.Turnoffthepowerswitchontheblackpowersupplybox.
Calibrationnotes
4/16/2012:ELWmanuallyresetverticalcalibrationusing8.48kAstandard(measured704.105,
3x),Brukershouldbesendingthecorrectcalibrationprofilesometimesoon.
Forreference:BrukerCustomerService:8008739750.
4