R
DELAVIN
3
R
DELAVIN
d.
e.
f.
g.
3
3
2
2
3
4
19
a. b.
Bracket core
Front
c.
Bracket core screw
2
2
4
19
1.Determine a suitable location and place the stainless steel spacers on the support rods as shown.
Use the Allen key (21) to loosen the screws on the rail bracket (2) and the glass door stop （3).
First put (3) on the stainless steel support rod and fix it in the approximate position as shown in the figure,
Then place (2) on both ends of the stainless steel support rod. Then disassemble (19) as shown in the
figure, and fix half of it at the small hole of the stainless steel support rod.
2
3
4
a.
b.
17
Wood
ATTENTION:
2.Place the Stationary Glass (17), align the
hole above the glass with the Glass
Bracket (19) that has been fixed with the
stainless steel support rod, Cover the other
half of the Glass Bracket (19) to lock the
glass (two spacers are placed separately to
protect the glass).
Never set your glass down directly
onto a tile or concrete floor.
Always use a piece of wood or cardboard
and leave the corner pads on the glass
until it becomes necessary to remove
them to protect the bottom edge and
the corners of the glass from breakage.
To Next Page
Loading...