DELAVIN W101 - Mounting Guide Rail Brackets

R
DELAVIN
5 6
R
DELAVIN
3. Place the Measuring Tool(23) vertically against the wall on the floor, mark the wall
according to the holes in the Measuring Tool(23).
Drill holes in the determined position and apply silicone into the holes, insert the
Wall anchors (15) for the Guide Rail Bracket.
Screw M5*40
a.
d.
e.
f .
b.
c.
I
II
23
18
15
2
Measuring
tool
Wall Anchor
4.Divide the Guide Rail Bracket(2) into two parts: I and II
Fix part I of the Guide Rail Bracket(2) to the wall on both sides with 5*40 screws
(18) as shown in the picture g.
The other side of the Guide Rail Bracket (2) is installed in the same way.Finally,
remove the II part of the Guide Rail Brackets (2) and insert it into the Upper Guide
Rail (4).