DELAVIN W101 - Door Assembly and Installation; Attaching Rollers and Handles

R
DELAVIN
R
DELAVIN
e.
g
.
16
f.
4.8*32
2
2
a.
b.
c.
d.
5
21
5
7
7
6
d.
1
5
5
7
6
b.
a.
c.
e.
Attention: Need to loosen the small allen screws before
loosening the long allen screw on the roller
6. Loosen the Rollers (5) screw as shown in the figure to
disassemble the rollers (5) and install the rollers to the glass
door (7). And then Install Handle (6) and Bumper Strip (1) to
the glass door (7).
7 8
5
7
5. Place the Stationary glass (17) back into the designated position. Slide the II part
of the Guide Rail Brackets (2) to the two end sides of the Upper Guide Rail (4),
then connect II and I part of the Guide Rail Brackets (2). Tighten the set screws on
the Guide rail bracket (2) with Allen Key (21) to secure the guide rail to the wall.
Cover the L wall cover (16) with glass on one side, and lock the L wall cover on the
wall with Screw M4.8X32 (22) on the other side.