Delco DCV2420 - Quick Setup Guide; Install the Wheels; Install the Handle; Add;Check Oil

8- ENG
qUICk SETUp GUIDE
WARNING: To reduce the risk of injury, read the pressure washer instruction
manual and the engine instruction manual before operating pressure washer.
B
Install the Handle
Place handle onto
frame, depress the snap
buttons, and slide the handle
assembly onto the frame until
snap buttons snap into place.
c
Add/Check Oil
The engine is shipped without
oil. Before starting engine, add
the oil provided. Check oil level prior
to each use. Refer to Engine Owner’s
Manual for complete procedure.
D
Add Gasoline
In a well ventilated
outdoor area add fresh,
high quality, unleaded gasoline
with a pump octane rating of
86 or higher. Do not overfill.
Wipe up spilled fuel before
starting the engine. Refer to
Engine Owner's Manual
for complete procedure.
a
Install the Wheels
Slide the axle pin through the
wheel, formed washer, frame and
other formed washer. Slide clip
through hole in axle pin to secure wheel
in place. Repeat steps for second wheel.
qUICk START GUIDE
DANGER:
 •Never run engine indoors or in enclosed, poorly ventilated areas. Engine
exhaust contains carbon monoxide, an odorless and deadly gas.
 •Riskoffluidinjectionandlaceration.Whenusingthehighpressuresetting,DO
NOTallowthehighpressurespraytocomeincontactwithunprotectedskin,
eyes or with any pets or animals. Serious injury will occur.