Delem
V0802, 4.15
Parameter: 9 - 12
Distance A-D
Range : 0 - 9999
Default : 0
Units : mm
Function
Dimensions of a crossbeam backgauge system.
Description
These four distances are used to describe the geometry of the machine in case a crossbeam is
used.
The meaning of these dimensions is:
A: Length of fingers measured perpendicular from the turning point of the Z-axes to the end
of the fingers.
B: Distance between the turning points of the crossbeam.
C: Z1-axis position of the left turning point of the crossbeam.
D: Radius of the end of the finger (0=no radius).
Figure 4.5.d
To Next Page
Loading...
