Delem
V1101, 5.1
5 Auxiliary axes parameters
5.1 Introduction
In this chapter the machine parameters for several axis types are explained.
Paragraph 5.2 shows standard parameters for axes.
Paragraph 5.3 shows parameters for Servo axes.
Paragraph 5.4 shows all parameters for axes with AC drives.
Parameters for special axes are explained in chapters 6 through 9.
5.2 Standard axis parameters
On the following pages the standard axis parameters are explained.
These standard parameters will occur on almost all axes, regardless of Servo control or AC
control.
To Next Page
Loading...
