Delem
V1101, 4.21
The contents of the spindle correction tables can be edited on the DA control. When a spindle
correction table is installed for a servo axis the following soft key will appear in the auxiliary
axis screen:
S6: edit table
If S6 is selected, a submenu is opened. The actual contents of the table are shown on the screen.
Two columns are shown with the following tags:
X = axis position
C= correction value
The tags shown on the screen should correspond with the tags as specified in the table file.
With the softkeys the following functions are available:
S3 modify entry the contents of the line, which is selected with the cursor,
can be modified
S4 new entry enter a new line in the table
S5 delete entry the line, which is selected with the cursor, can be deleted
S6 save table the file, as shown on the screen, is saved to the internal
memory
To Next Page
Loading...
