Delem DA-65 - Page 182

Delem
V1101, 6.12
Parameter 23: Hysteresis
Range : 0.00 - 100
Default : 1
Units : DA-points
Function
To determine the switch-off point (switch-off zone) for the programmed DA-value. See also
figure 6.1a.
Description
The hysteresis value determines the switch-off zone around the DA-value in the feedback
application. The value of the hysteresis depends on your crowning device. A hysteresis might be
necessary to stop the crowning device at the correct position, because of the inertia of the
crowning device.
Parameter 14: Default value
Range : -999999.00 - +999999.00
Default : 0.00
Units : display units
Function
Initial axis value
Description
The default value is used as initial value for the axis in case of a new numerical program (data
preparation menu).