Delem DA-65 - Page 2

Delem
V0303, 0.2
GENERAL INTRODUCTION
In this machine parameter manual you find the explanation on:
• the input and output signals (X- and Y-axis and general);
• the selection possibilities of the machine parameter menu;
• the value and function of the machine parameters of the X- and Y-axis;
• the auxiliary axes with corresponding parameters.
The first chapter describes the function of the general input and output signals and the input and
output signals of the X- and Y-axis and in what way these signals should be connected to the
axis module. A DA-60 series control with a DM02 gives the basic machine configuration.
The High Speed Bus (HSB) takes care of the communication between the control and the
modules. Via this HSB line the modules are programmed with the appropriate machine
parameter values to control the axes. The programmed values of the axes are compared with the
actual axes positions and the machine parameter settings. If the ‘new’ values are within the range
the ‘new’ values become the actual values.
The machine parameters (including all axis parameters) are programmed in the machine
parameter menu of the control. Besides the programming of the machine parameters you have
several other selection possibilities in this machine parameter menu. These selection possibilities
are explained in chapter 2.
The basic machine parameters are to control the Y-axis. In chapter 3 these machine parameters
are explained. The explanation comprises the parameter range, the default value, the parameter
function and a description.
From chapter 4 until chapter 10 the parameters of the auxiliary axes and special functions are
given. The auxiliary axes are grouped per type of axis. The next type of axes and special
functions are explained:
• auxiliary axes (chapter 4);
• axes types and parameters (chapter 5);
• crowning (chapter 6);
• digital outputs (chapter 7);
• I-axes (chapter 8);
• part support (chapter 9);
• sensor machine parameters (chapter 10, not yet implemented).
This manual is valid for the following Delem control types:
• DA-65 (V7)
• DA-69 (V7)
• DA-68PL (V7)
• DA on Windows (V1)