Delem DA-65 - Input and Output Signals; Y-axis Input Signals; Y-axis Output Signals; X-axis Signals

Delem
V0303, 0.3
MACHINE PARAMETERS MANUAL
Table of contents
PAGE
GENERAL INTRODUCTION................................................................................................ 0.2
Table of contents......................................................................................................................0.3
1. INPUT AND OUTPUT SIGNALS............................................................................1.1
1.1. Introduction....................................................................................................1.1
1.2. Y-axis input signals........................................................................................ 1.1
1.3. Y-axis output signals...................................................................................... 1.2
1.4. X-axis signals................................................................................................. 1.4
1.5. Axis signals.................................................................................................... 1.4
1.6. Various input and output signals.................................................................... 1.5
2. MACHINE PARAMETERS MENU......................................................................... 2.1
2.1. Introduction....................................................................................................2.1
2.2. Selection procedure of machine parameters menu......................................... 2.1
2.3. Y-axis and general parameters....................................................................... 2.2
2.4. Auxiliary Axes ............................................................................................... 2.2
2.5. Module configuration..................................................................................... 2.3
2.6. Update control................................................................................................ 2.5
2.7. Machine parameters backup........................................................................... 2.8
2.8. Changing the menu name............................................................................... 2.8
2.9. Changing the access code .............................................................................. 2.9
2.10. Options...........................................................................................................2.10
2.11. Leaving the machine parameters menu.......................................................... 2.11
3. Y-AXIS AND GENERAL PARAMETERS ............................................................... 3.0
Parameter 1
Service row 1/0...................................................................................................... 3.1
Parameter 2
Y-max .................................................................................................................... 3.2
Parameter 3
Y-min..................................................................................................................... 3.3
Parameter 4
Y-direction +/- (1/0).............................................................................................. 3.4
Parameter 5
Linear Scale Ref. left (Y1) ................................................................................... 3.5
Parameter 6
Linear Scale Ref. right (Y1) ................................................................................3.6
Parameter 7
Tool Reference...................................................................................................... 3.7
Parameter TR