Delem
V1101, 9.34
Parameter: RF
Delay before retour factor
Range : 0.0 - 9.9
Default : 1.0
Unit : -
Function
Multiply factor, used to program the time the part support arm must stay on the final position.
The parameter ‘Delay Before Opening’ (chapter 3, parameter 36) is multiplied by ‘Delay Before
Retour Factor’ to program how long the part support arm must stay.
If ‘Delay Before Retour Factor’ is set to 1.0, pressbeam and part support arm will move back
simultaneously.
To Next Page
Loading...
