Delem
V1101, 2.9
After ‘init memory’ in the diagnostic mode the original text string (DELEM) appears again. See
also section 2.9 ‘changing the access code’
2.9 Changing the access code
You can change the access code of the machine parameters menu. The procedure is as follows:
• enter old code;
• enter new code;
• (re)enter new code;
• press the enter key to accept the new value.
Without the correct access code it is impossible to enter the machine parameters menu.
Therefore, be sure if you want to change the default access code (14753). There is one option to
reset the access code to its default code. After ‘initialise memory’ in the diagnostic mode the
access code is again reset to the default code.
To Next Page
Loading...
