Delem
V1101, 3.2
Parameter 2: Y-max
Range : 0.00 - 9999.99
Default : 150.00
Units : mm
Function
Maximal Y-axis value
Description
The maximum position the beam can be moved to. This value is used as a soft limit.When the
start button on the control is pressed, the control checks all Y-axis parameters, which are
programmed or computed. If a programmed or computed Y-axis value is greater than Y-max the
value is limited at the Y-max value and the following error message appears on the screen:
** Y-axis >>limit **
The following causes for this error message are possible:
- programmed or computed bending position >Y- max
- programmed or computed mute point > Y-max
- computed clamping point > Y-max
To Next Page
Loading...
