Delem
V1101, 3.49
Parameter 49: Pressing gain trim
Range : -1.0 - +1.0
Default : 0.0
Units : -
Function
To adjust the gain in the pressing phase of the beam.
Description
It is sometimes desired to adjust (trim) the preset gain of the pressbrake movement during the
pressing and decompressing phase. Especially when you have some vibrations in the pressing
phase you can decrease the gain. But also the positioning at the programmed position must be
correct.
Programming 0.0 will give the preset standard value for the gain.
To Next Page
Loading...
