Delem DA-69 - Page 88

Delem
V1101, 3.52
Parameter 52: Inertia upper beam
Range : 0 - 99999
Default : 776
Units : 1000 cm
4
Function
The inertia of the machine upper beam is used to compute table deflection.
Description
This parameter is used to compute the machine table deflection. The table deflection is only
computed when a crowning adjustment device is connected. (See chapter 6).
See also machine parameters ‘Inertia under beam’ and ‘Machine length between the cylinders’.
Example
Inertia = 1349000
Program: 1349