Delem DA-69 - Page 87

Delem
V1101, 3.51
Parameter 51: Inertia under beam
Range : 0 - 99999
Default : 624
Units : 1000 cm
4
Function
The inertia of the machine table is used to compute table deflection.
Description
This parameter is used to compute the machine table deflection. The table deflection is only
computed when a crowning adjustment device is connected (see chapter 6).
See also machine parameters ‘Machine length between the cylinders’ and ‘Inertia upper beam’.
Example
Inertia = 1349000
Program: 1349