Delfin ElastiMeter - Appendix A: Display Messages; Explanation of Display Messages

ElastiMeter User Manual version 1.6
15.8.2018
13
APPENDIX A
APPENDIX A: DISPLAY MESSAGES
DISPLAY MESSAGES
Message
Explanation
WAIT
Initial stabilization in process
READY
Instrument is ready to measure
MEASURE sample 2/5
Instrument is ready to measure
POWER OFF
Instrument turns off
NO PC
No PC connection detected
USER ERROR
The applied force or measurement speed is not
correct, or the probe is left on the skin for too long
LO FORCE
Applied contact force too low
HI FORCE
Applied contact force too high
OK FORCE
Applied contact force correct
LO SPEED
Skin contact too slow
HI SPEED
Skin contact too quick or indenter not
perpendicularly placed on the skin
OK SPEED
Measurement speed correct
OFF SKIN
Probe left on the skin for too long
TOO LONG CONTACT
Probe had been left on the skin for too long
Low battery
Battery voltage low, change batteries
Replace batteries
Battery voltage too low to operate, change batteries
immediately