4
• DO NOT operate the control unit with a free cable end! Only switch on the appliance if you have connected all
the cables and made sure that they are connected correctly!
• Do not use the device in a humid, environment, the device may only be used indoors in a dry area. Otherwise
there is a risk of short circuit and electric shock!
• Only operate the device with the specied voltage (100 - 240 V AC)!
• Do not touch the device with wet hands! It is strictly forbidden to touch the device, including the cable,
with wet hands!
• Before applying power to the device, check that the connection is correct and that the insulation is intact.
Improper wiring can lead to accidents and property damage!
• Depending on the power of the consumer connected to the device, choose the cable required for connection,
we recommend using cables with a cross section of at least 2 x 1 mm
2
! During use, pay attention to the
integrity of the mains cable, avoid edges or objects that can damage the surface of the cable.
• Do not operate a device with a higher power rating than specied in the specication, as this may damage
the device! In the event of damage, do not use the device, contact a specialist workshop!
• Secure the device to install the device safely. Use self-adhesive or a screw that can be applied to the
mounting surface.
• Install the device in such a way that it is not exposed to direct sunlight or heat sources!
• Do not cover the device with any material! Do not disassemble the device! It is forbidden to change the
parameters of the device!
• The manufacturer and the distributor are not liable for any damage resulting from improper use!
INSTALLATION OF THE CONTROL UNIT:
Lout
Lout Lin
Input
Nout
Nin
Lin S1 S2 Nin Nout
USER MANUAL AND INSTALLATION GUIDE
To Next Page
Loading...