Need help?Do you have a question about the Dell EMC VEP4600 and is the answer not in the manual?
General| Model | VEP4600 |
|---|---|
| Manufacturer | Dell EMC |
| Power Supply | Dual Redundant Power Supplies |
| Form Factor | 1U |
| CPU | Intel Xeon D-1500 Series |
| Memory | Up to 128GB DDR4 |
| Storage | M.2 SSD slot |
| Network Interfaces | 2 x 1GbE RJ45 |
| Expansion Slots | 1 x PCIe Gen3 |
| Operating System Support | Various Linux distributions |
| Dimensions (H x W x D) | 43mm x 430mm x 550mm |
Steps to create a bootable USB for DiagOS installation.
Steps to set up the BIOS to boot from the prepared USB.
Steps to update the Diag Tools software.
Command to check current firmware versions on the VEP4600.
Steps to download and prepare the firmware updater on USB.
Commands to check firmware versions using BMC.
Steps to configure BMC IP address settings within the BIOS.
Procedure to upgrade rNDC firmware on ESXi.
Procedure to upgrade rNDC firmware on CentOS.
Steps to prepare a bootable USB drive for OS installation.
Guide to downloading the Rufus utility for USB creation.
Steps to configure BIOS to boot from a USB drive.
Instructions for installing the Red Hat Enterprise Linux OS.
Steps to configure BIOS for USB booting.
Procedure for installing the Ubuntu operating system.
Steps to configure BIOS for USB booting.
Procedure for installing the Adva OS.
Steps to configure BIOS for USB booting.
Procedure for installing the ESXi operating system.
To Next Page
