240 Copying
5
If necessary, customize the copy settings including the number of copies,
contrast, and image quality. See "Setting Copy Options" on page 238.
6
Press the
(Start)
button to begin copying.
Reduce/Enlarge
To reduce or enlarge the size of a copied image, from 25 percent to 400
percent when you copy original documents from the document glass or ADF.
NOTE: When you make a reduced copy, black lines may appear at the bottom of
your copy.
NOTE: This item is available only when Multiple-Up is set to Off or
Manual.
1
Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the
document cover.
For details about loading a document, see "Loading an Original Document
on the ADF" on page 296.
2
Press the
(Copy)
button.
3
Press the
button
until
Reduce/Enlarge
is highlighted, and then
press the button.
4
Press the
button
to select the desired settings, and then press the
button.
mm series
NOTE: Values marked by an asterisk (
*
) are the factory default menu settings.
Auto Automatically determines which output mode for the copy job
200%
A5ï‚®A4 (141%)
A5ï‚®B5 (122%)
100%*
To Next Page
Loading...
Need help?
General
