24 Using Your Projector
1 LAMP warning light If the LAMP amber indicator is on or blinking,
one of the following problems could be occurring:
• Lamp is reaching its end of usable life
• Lamp module is not properly installed
• Lamp driver failure
• Color wheel failure
For more information, see "Troubleshooting Your
Projector" on page 61 and "Guiding Signals" on
page 65.
2 TEMP warning light If the TEMP amber indicator is on or blinking,
one of the following problems could be occurring:
• Internal temperature of the projector is too
high
• Color wheel failure
For more information, see "Troubleshooting Your
Projector" on page 61 and "Guiding Signals" on
page 65.
3 Power Turns the projector on or off. For more
information, see "Turning Your Projector On" on
page 19 and "Turning Your Projector Off" on
page 19.
4 Up / Keystone
adjustment
Press to navigate through the On-Screen Display
(OSD) Menu items.
Press to adjust image distortion caused by tilting
the projector (+40/-35 degrees).
5 Right / Auto
Adjust~
Press to navigate through the On-Screen Display
(OSD) Menu items.
Press to synchronize the projector to the input
source.
NOTE: Auto Adjust does not operate if the on-
screen display (OSD) is displayed.
6 IR Receiver Point the remote control towards the IR receiver
and press a button.
To Next Page
Loading...
