Using Your Projector 47
NOTE: Closed caption option is available for NTSC only.
TEST PATTERN—Test Pattern is used to test focus and resolution.
You can enable or disable the Test Pattern by selecting Off, 1 or 2. You can also
invoke the Test Pattern 1 by pressing and holding down and buttons on the
control panel simultaneously for 2 seconds. You can also invoke the test pattern 2
by pressing and holding down and buttons on the control panel
simultaneously for 2 seconds.
FACTORY RESET—Select and press on the control panel or press
Enter
button
on the remote control to reset all settings to its factory default, the warning
message below appears.
Reset items include both computer sources and video source settings.
Test Pattern 1:
Test Pattern 2:
To Next Page
Loading...
