Settings
* Factory default setting
Standard
Fastbytes*
Honor Init Determine whether the printer honors hardware initialization requests from the
computer. The computer requests initialization by activating the INIT signal on the
parallel interface.
Many personal computers activate the INIT signal each time the computer is turned on
and off.
On
Off*
Parallel
Mode 2
Determine whether the parallel port data is sampled on the leading (on) or trailing
(off) edge of the strobe.
Off
On*
NOTE: This menu appears only if supported by the parallel port.
MAC Binary
PS
Configure the printer to process Macintosh binary PostScript emulation print jobs.
Off
On
Auto*
Parallel With
ENA
ENA
Address
ENA
Netmask
ENA
Gateway
Configure the parallel port ENA address, Netmask, and Gateway settings.
4 field IP address (0.0.0.0*)
NOTE: These settings are shown only when ENA is attached through the parallel port.
Mode Mode Main Menu
Settings General Settings
Setup Menu
Finishing Menu
Quality Menu
Utilities Menu
PostScript Menu
PCL Emul Menu
General Settings Mode
Main Menu Mode Main Menu
General Settings Display Language
To Next Page
Loading...
