System setup options
NOTE: Depending on the and its installed devices, the items listed in this section may or may not appear.
General screen options
This section lists the primary hardware features of your computer.
Option Description
System
Information
• System Information: Displays BIOS Version, Service Tag, Asset Tag, Ownership Tag, Ownership Date,
Manufacture Date, and the Express Service Code.
• Memory Information: Displays Memory Installed, Memory Available, Memory Speed, Memory Channels Mode,
Memory Technology, DIMM
1 Size, DIMM 2Size.
• Processor Information: Displays Processor Type, Core Count, Processor ID, Current Clock Speed, Minimum
Clock Speed, Maximum Clock Speed, Processor L2 Cache, Processor L3 Cache, HT Capable, and 64-Bit
technology.
• Device Information: Displays Primary Hard Drive, SATA-0, SATA-1, SATA-2, SATA-3, LOM MAC Address,
Video Controller, Audio Controller, WiFi Device, M.2PCIe SSD-0, Dock eSATA Device, Video BIOS Version,
Video Memory, Panel Type, Native Resolution, WiGig Device, Cellular Device, Bluetooth Device.
Boot Sequence
Boot Sequence Allows you to change the order in which the computer attempts to find an operating
system. The options are:
• Windows Boot Manager
• PEBOOT
By default, all the options are checked. You can also deselect any option or change the
boot order.
Boot List Options Allows you to change the boot list option:
• Legacy
• UEFI (default)
Advanced Boot
Options
This option allows you the legacy option ROMs to load.
• By default, the Enable Legacy Option ROMs is enabled
• This option allows you the legacy option ROMs to load. By default, the Enable Attemot Legacy Boot is
disabled.
.
UEFI Boot Path
Security
This options control whether or not the system will prompt the user to enter the Admin password (if set) when
booting a UEFI boot path from the F12 Boot Menu
• Always Except Internal HDD (default)
• Always
• Never
Date/Time Allows you to change the date and time.
System Configuration screen options
Option
Description
Integrated NIC Allows you to configure the integrated network controller. The options are:
• Disabled
• Enabled
• Enabled w/PXE: This option is enabled by default.
SATA Operation Allows you to configure the internal SATA hard-drive controller. The options are:
18 System setup
To Next Page
Loading...
