Installing the SD card reader
Steps
1. Place the SD card reader on the chassis.
2. Tighten the screws that secure the SD card reader to the computer.
3. Route the power supply unit cables into the retention clips.
4. Install the:
a. power supply unit
b. optical drive
c. hard drive assembly
d. front bezel
e. cover
5. Follow the procedure in After Working Inside Your Computer.
Installing the optional SSD card
Steps
1. Remove the:
a. cover
b. front bezel
2. Peel the adhesive tape (blue) from the rubber.
22
Removing and installing components
To Next Page
Loading...
