3. Remove the front bezel.
4. Remove the 3.5-inch hard drive, if applicable.
5. Remove the disk-drive cage.
About this task
NOTE: The optical drive is located within the disk-drive cage. Follow the below-mentioned procedure on the disk-drive
cage to remove or install the optical drive.
The following images indicate the location of the optical-drive assembly and provide a visual representation of the removal
procedure.
Figure 13. Removing the optical drive
Steps
1. Remove the screw (M2x2) to release the optical drive from the disk-drive cage.
2. Gently slide the optical drive out of the disk-drive cage.
52
Removing and installing Customer Replaceable Units (CRUs)
Restricted - Confidential
To Next Page
Loading...
