Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the optional HDMI module and provide a visual representation of the installation
procedure.
Figure 89. Installing the optional HDMI module
Steps
1. Using a screwdriver, remove the optional-module cover from the chassis.
NOTE: This step is applicable only when the optional HDMI module is being installed for the first time.
NOTE: To remove the optional-module cover, insert a flat-head screwdriver in the hole of the cover, push the cover to
release it, and then lift the cover off the chassis.
2. Insert the optional HDMI module in the slot on the chassis.
3. Connect the optional HDMI-module cable to the connector (VIDEO) on the system board .
4. Replace the two screws (M3X3) to secure the optional HDMI module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
118
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
