Figure 104. Installing the system board
5. Close the PCIe door and press it gently until it clicks in place on the chassis.
6. Align the tabs on the front I/O-bracket with the slots on the chassis.
7. Replace the screw (#6-32) to secure the front I/O-bracket to the chassis.
Figure 105. Installing the system board
Next steps
1. Install the optional I/O modules, if applicable.
2. Install the voltage-regulator heat sink.
3. Install the processor.
4. Install the system fan.
5. Install the processor fan and heat-sink assembly (for 65 W processors) or the processor fan and heat-sink assembly (for 125
W processors), whichever is applicable.
Removing and installing Field Replaceable Units (FRUs)
133
To Next Page
Loading...
