Steps
1. Align the screw holes and place the secondary 2.5-inch hard drive into the hard-drive bracket.
2. Replace the two (M3x3.5) screws that secure the secondary 2.5-inch hard drive to the hard-drive bracket.
3. Align the screw holes and place the primary 2.5-inch hard drive into the hard drive bracket.
4. Replace the two (M3x3.5) screws that secure the primary 2.5-inch hard drive to the hard drive bracket.
5. Align the hard drive to the side of the hard drive bracket.
6. Pull the other end of the hard drive bracket to insert the pins on the bracket into the slot on the hard drive.
7. Insert the hard drive into the hard drive bracket until it clicks into place.
Removing and installing components
25
To Next Page
Loading...
