86 Removing and Installing Parts
www.dell.com | support.dell.com
Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before removing the cover.
NOTE: If you are adding a floppy drive, see "Installing a Floppy Drive" on page 88.
Removing a Floppy Drive
1
Follow the procedures in "Before You Begin" on page 53.
2
Remove the drive panel (see page 77).
3
Disconnect the power and data cables from the back of the floppy drive.
NOTE: If you are installing a PCI Express x16 card, this card may cover the floppy-drive connectors.
Remove this card before connecting the floppy-drive cables
.
power cable
data cable
To Next Page
Loading...
