94 Removing and Installing Parts
Installing a Hard Drive
1
Unpack the replacement hard drive, and prepare it for installation.
2
Check the documentation for the drive to verify that the drive is configured for your
computer.
3
If your replacement hard drive does not have the hard drive bracket attached, remove the
bracket from the old hard drive by unsnapping it from the drive.
4
Snap the hard drive bracket onto the replacement hard drive.
5
Install the hard drive into the computer by sliding the drive into place until you feel it click
into place.
6
Connect the power and hard drive cables to the hard drive.
7
Check all connectors to be certain that they are properly cabled and firmly seated.
8
Close the computer cover.
hard drive
hard drive bracket
hard drive cable
power cable
To Next Page
Loading...
