88 Removing and Installing Parts
3
Gently slide the drive into place until you feel a click or feel the drive securely installed.
4
Connect the power and hard-drive cables to the drive.
5
Check all connectors to be certain that they are properly cabled and firmly seated.
6
Replace the computer cover (see "Replacing the Computer Cover" on page 102).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the
computer.
7
Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for
drive operation.
drive
hard drive bracket
serial ATA
data cable
power cable
To Next Page
Loading...
