Removing and Installing Parts 95
5
Disconnect the FlexBay USB cable on the back of the Media Card Reader from the Media Card
Reader connector on the system board (see "System Board Components" on page 68) and route the
cable through the cable routing clip.
6
Slide the drive latch release toward the bottom of the computer and, without releasing the drive latch
release, slide the Media Card Reader out through the front of the computer.
7
Replace the drive panel (see "Replacing the Drive Panel." on page 83).
8
Replace the computer cover (see "Replacing the Computer Cover" on page 102).
Media Card Reader
sliding plate
drive latch release
To Next Page
Loading...
