The computer automatically starts the system setup program, adds the Maintenance option to the menu bar, and displays the Maintenance
screen.
3. Select Clear All Passwords and press <Enter> twice.
4. Press <F10> to exit the system setup program and save any changes you made.
5. Turn off the system, remove the computer cover and support beam, and replace the jumper plug on pins 1 and 2 of configuration jumper
J8A1 to select Normal mode.
6. Replace the cover and support beam and boot the system.
7. Reenter the system setup program and reset the system configuration information.
Back to Contents Page
To Next Page
Loading...
