About Your Monitor 13
*Zero-power consumption in OFF mode can only be achieved by disconnecting the
main cable from the monitor.
**Maximum power consumption with max luminance and contrast.
This document is informational only and reflects laboratory performance. Your product
may perform differently, depending on the software, components and peripherals you
ordered and shall have no obligation to update such information. Accordingly, the
customer should not rely upon this information in making decisions about electrical
tolerances or otherwise. No warranty as to accuracy or completeness is expressed or
implied.
16.0 W
50.6 kWh
Power Consumption
P
Total Energy Consumption(TEC)
on
VESA Modes
Horizontal
Sync
Vertical
Sync
Video
Power
Indicator
Power Consumption
Normal operation Active Active Active White 24 W (Maximum)**
18 W (Typical)
Active-off mode Inactive Inactive Blanked Glowing
white
Less than 0.3 W
Switch off - - Off Less than 0.3 W
Power Management Modes
If you have VESA’s DPM
TM
compliance display card or software installed in your PC,
the monitor can automatically reduce its power consumption when not in use. This
is referred to as
Power Save Mode*. If the computer detects input from the
keyboard, mouse, or other input devices, the monitor automatically resumes
functioning. The following table shows the power consumption and signaling of
this automatic power saving feature.
NOTE:
P
on :
Power consumption of on Mode as measured with reference to Energy Star test method.
TEC : Total energy consumption in kWh measured with reference to Energy Star test
method.
The OSD will only function in the normal operation mode. When any button except
power button is pressed in Active-off mode, the following messages will be displayed:
Activate the computer and monitor to gain access to the OSD.
To Next Page
