Installation procedure for SSD
About this task
Installation of the SSD requires removal of the bottom panel, and the SSD bracket is preinstalled in the EGW-5200.
Steps
1. Remove the eight screws from the bottom panel of the EGW-5200, as shown in the following figure, and remove the bottom
panel.
Figure 1. Bottom panel screw locations
NOTE: If 4G or 5G is installed, you must also remove the remaining four screws.
2. Remove the four screws of the SSD bracket, as shown in the following figure.
I
4 Installation procedure for SSD
To Next Page
Loading...
