Dell EMC VxFlex Series - Page 256

Table 33 Default ports (continued)
Port used by Port # Protocol File to change Field to modify
(or to add, if it
does not exist)
Notes
SNMP 162 SNMP v2
over UDP
<gateway
installation
directory>/
webapps/ROOT/WEB-
INF/classes/
gatewayUserProper
ties
snmp.port
SNMP traps for system alerts are
sent to a trap receiver via this port.
The VxFlex OS Gateway sends
messages to:
snmp.traps_receiver_ip on the port
snmp.port
If you change the port number,
restart the VxFlex OS Gateway
afterwards.
SDBG for MDM
(Manager)
25620 Used by VxFlex OS internal
debugging tools to extract live
information from the system for
debugging purposes.
When multiple SDSs are installed on
the same physical server, use ports
2564+ x , where x is the index of the
SDS (for example, 25641, 25642).
SDBG for MDM
(Tie Breaker)
25600
SDBG for SDS 25640
AMS (secure) 22 SSH Note: Cannot be modified, and must be
available
The AMS uses this port to connect
to the SVM and hosts via SSH
during deployment and post
deployment for management and
monitoring.
AMS (ICMP) N/A ICMP Note: Cannot be modified, and must be
available
Internet Control Message Protocol
(ICMP) is a supporting protocol in
the Internet protocol suite.
The AMS uses this protocol to ping
the SVM, host and iDRAC IPs to
check connectivity.
AMS (secure) 443
<AMS installation
directory>\conf
\server.xml
redirectPort
= <NEW_PORT>
Connector
port= <NEW_P
ORT>
After changing the port, you must
restart the VxFlex OS Gateway
service/daemon:
l
Linux: Run service
scaleio-gateway restart
l
Windows: Restart the VxFlex OS
Gateway service
AMS (not
secure)
80
<AMS installation
directory>\conf
\server.xml
Connector
port= <NEW_P
ORT>
Common Tasks
256 Dell EMC VxFlex Ready Node AMS User Guide