7. control module 0
Figure 12. Cabling an iSCSI SAN-Attached Cluster to a Dell EqualLogic PS6510 Storage Array
1. cluster node 1
2. cluster node 2
3. switch 0
4. switch 1
5. Dell EqualLogic PS6510 storage system
6. control module 1
7. control module 0
Cabling The Dell EqualLogic PS5000/PS5500 Storage Arrays
1. Connect a network cable from the network switch 0 to Ethernet 0 on the control module 1.
2. Connect a network cable from the network switch 0 to Ethernet 1 on the control module 1.
3. Connect a network cable from the network switch 1 to Ethernet 2 on the control module 1.
4. Connect a network cable from the network switch 1 to Ethernet 0 on the control module 0.
5. Connect a network cable from the network switch 1 to Ethernet 1 on the control module 0.
6. Connect a network cable from the network switch 0 to Ethernet 2 on the control module 0.
7. Repeat steps 1 to 6 to connect the additional Dell EqualLogic PS5000/PS5500 storage array(s) to the iSCSI switches.
For more information, see the figures below.
20
To Next Page
Loading...
