Dell iDRAC 7 - Page 55

Object Description Usage Example
High (66% PWM) over the
baseline fan speed
racadm set
system.thermalsetting
s FanSpeedOffset 1
FanSpeedLowOffsetVal
• Getting this variable reads
the fan speed offset value
in %PWM for Low Fan
Speed Offset setting.
• This value depends on the
system.
• Use FanSpeedOffset
object to set this value
using index value 0.
Values from 0-100
racadm get
system.thermalsetting
s
FanSpeedLowOffsetVal
This returns a value such as
“23”. This means that when
you use the following
command, it applies a fan
speed offset of Low (23%
PWM) over baseline fan speed
racadm set
system.thermalsetting
s FanSpeedOffset 0
FanSpeedMaxOffsetVal
• Getting this variable reads
the fan speed offset value
in %PWM for Max Fan
Speed Offset setting.
• This value depends on the
system.
• Use FanSpeedOffset to
set this value using index
value 3
Values from 0-100
racadm get
system.thermalsetting
s
FanSpeedMaxOffsetVal
This returns a value such as
“100”. This means that when
you use the following
command, it applies a fan
speed offset of Max (meaning
full speed, 100% PWM).
Usually, this offset results in
fan speed increasing to full
speed.
racadm set
system.thermalsetting
s FanSpeedOffset 3
FanSpeedMediumOffsetV
al
• Getting this variable reads
the fan speed offset value
in %PWM for Medium Fan
Speed Offset setting.
• This value depends on the
system.
• Use FanSpeedOffset
object to set this value
using index value 2
Values from 0-100
racadm get
system.thermalsetting
s
FanSpeedMediumOffsetV
al
This returns a value such as
“47”. This means that when
you use the following
command, it applies a fan
speed offset of Medium (47%
PWM) over baseline fan speed
racadm set
system.thermalsetting
s FanSpeedOffset 2
FanSpeedOffset
• Using this object with get
command displays the
existing Fan Speed Offset
value.
• Using this object with set
command allows setting
the required fan speed
offset value.
Values are:
• 0 — Low Fan Speed
• 1 — High Fan Speed
• 2 — Medium Fan Speed
• 3 — Max Fan Speed
• 255 — None
To view the existing setting:
racadm get
system.thermalsetting
s.FanSpeedOffset
55