I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the left fan.
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure.
Steps
1. Remove the two screws (M2x2) that secure the left-display hinge to the palm-rest and keyboard assembly.
2. Lift up the left-display hinge at an angle of 90 degrees.
3. Open the latch and disconnect the I/O-board cable from the I/O board.
4. Disconnect the coin-cell battery cable from the I/O board.
5. Open the latch and disconnect the power-button with optional fingerprint-reader cable from the I/O board.
6. Remove the screw (M2x2) that secures the I/O board to the palm-rest and keyboard assembly.
7. Gently slide out the universal headset port to release the I/O board from the palm-rest and keyboard assembly.
40
Removing and installing components
To Next Page
Loading...
