6. Remove the right fan.
7. Remove the heat sink.
NOTE: When removing the system board as a pre-requisite step, you may remove the system board with the heat sink
installed to maintain the thermal bond between the heat sink and the system board.
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
About this task
The following image indicates the connectors on your system board.
1. Display-cable connector
2. Right-fan cable connector
3. Wireless-card connector
4. I/O-board-cable connector
5. Left-fan cable connector
6. Speaker-cable connector
7. Touchpad-cable connector
8. M.2 solid-state drive slot
9. Keyboard cable connector
10. Keyboard-backlight cable connector
11. Battery cable connector
The following image(s) indicate the location of the system board and provides a visual representation of the removal procedure.
48
Removing and installing components
To Next Page
Loading...
