Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
ā Phillips screwdriver #1
ā Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Secured to Screw type Quantity Screw image
Base cover Palm-rest and keyboard
assembly
M2x4 5
Base cover Palm-rest and keyboard
assembly
M2x7 (captive) 2
Battery Palm-rest and keyboard
assembly
M2x3
ā 3-cell: 4
ā 4-cell: 5
Solid-state drive Palm-rest and keyboard
assembly
M2x3 1 per solid-state
drive
Fan Palm-rest and keyboard
assembly
M2x2 2
Wireless-card bracket System board M2x4 1
Touchpad Palm-rest and keyboard
assembly
M2x1.8 2
Touchpad bracket Palm-rest and keyboard
assembly
M1.6x2 3
Power-button with
optional fingerprint
reader
Palm-rest and keyboard
assembly
M2x3 1
2
10 Removing and installing components
To Next Page
Loading...
