Steps
1. Peel the tape that secures the battery cable to the 4-cell battery.
2. Disconnect the battery cable from the system board, if applicable.
3. Remove the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
4. Lift the battery off the palm-rest and keyboard assembly.
Installing the 4-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the 4-cell battery and provides a visual representation of the installation
procedure.
Removing and installing components
23
To Next Page
Loading...
