14. Remove the two screws that secure the display assembly to the computer base.
15. Lift and remove the display assembly from the computer base.
Replacing the Display Assembly
1. Place the display assembly in position and replace the two screws that secure the display assembly to the computer base.
2. Route the Mini-Card antenna cables, camera cable, and display cable through the routing guides.
3. Connect the camera cable to the system board connector.
4. Replace the palm rest (see Replacing the Palm Rest).
5. Replace the power button board (see Removing the Power Button Board).
6. Replace the keyboard (see Replacing the Keyboard).
7. Replace the center control cover (see Replacing the Center Control Cover).
8. Replace the two screws at the bottom of the computer.
To Next Page
Loading...
